Open a card. See the gears inside.

A card is one step of an analysis. Its face shows the values you set. Its gears show every operation that runs inside it, and the value each one really used.

What a gear is

A gear is one operation inside a card. If an operation can change the numbers, it is a gear, and you can see it.

Take Band Pass. On the card you set two numbers: 1 Hz and 40 Hz. Inside, 15 gears turn them into a filter: the transition width, the number of taps, the window, the gain, the phase, the edges.

On the cardtransition: auto
In the gearsauto → 413 taps

That resolved number is the one a reviewer asks for, and the one a script hides.

  • Signal

    Works on the recording itself. These gears form the signal line, from the card input to its output.

  • Setting

    Holds or computes one value: a cutoff, a window, a threshold. It feeds an operation by a data wire. When it says auto, the gear shows the rule it uses.

  • Construction

    Builds an object that an operation needs, such as a filter kernel.

  • In the panel

    Scroll the stack. Click a folder: it lies flat and opens its gears. Drag a gear to move it. Click a gear to read its settings. Press Esc to go back.

The gears tab of Signal Studio, open on the Band Pass card
The gears tab in the app, open on Band Pass. The high-pass taps read auto 413, the low-pass taps auto 255.

The gears below are read from the application source, card by card. Nothing is drawn by hand.